It is not related to G2, but Following this thread , a friend and I recently installed 50 ohm terminators on the two SMA ports (10 MHz input connector and transverter port) of our Anan 7000DLE and a 7000MKII (we had previously installed terminators on all the unused antenna ports). The result is a ...

Someone on facebook claimed, that 17m is distorted after this fix. I verified that, and confirm the problem, if using more than 20-25W. Issue was fixed on 15m with ferrites, but now 17m is distorted. Any ideas? Ugh, yep I noticed now 17M now has the problem. I am not sure how to fix this. I will pi...

All I have. That would be enough to fix the issue at hand. 5 min fix. Takes longer to take off the cover than apply the ferrites.

I fixed the audio issue on 15M by adding 3 type 31 ferrites circled in red.

So it appears this is a hardware issue, since Thetis is configured correctly as best as I can tell. I'm curious if anyone else has experienced this behavior before on the G2? I injected an S9 (-73dBm) signal into RX2 port and the 2nd receiver showed -115dbm response. That's -42dbm attenuation, makin...

Checked so far: correct ADC, bad database, old versions. Here's a couple of other ideas: - Perhaps there is a fault with the bandpass filters for the RX2 input. You might try selecting the bypass state on those. - Remove the covers and check for any loose RF connections or cables. Did RX2 ever work...

Your FPGA needs to be flashed with version 12. When you say RX2 you are referring to your second receiver? I think this as does the main VFO works between ANT1, 2, and 3. Maybe someone who does diversity receive will chime in as they will know better. Best 73 John I just upgraded to FPGA version 12...

I updated to the latest P2app version and updated FPGA and the same issue persists: SATURN Protocol 2 App. press 'x <enter>' in console to close register access connected to /dev/xdma0_user FPGA BIT file data code = 30092023 Product: Saturn; Version = 2 FPGA Firmware loaded: Saturn, full function; F...

KA1GXR wrote:Try reset to default for ADC.

TOM
KA1GXR

That's the first thing I tried. Do I need to update my p2app client to a newer version?

I recently hooked up a receive antenna to the RX2 port on the back of the G2. I then pressed the RX2 button in Thetis and observed a noise floor of -132. This was very low for me. When I hook up the same antenna to Ant2 port the noise floor is -118. All of the signals on the 2nd receiver are all ver...