Page 1 of 1
Thetis opening with Panafall terminator too low
Posted: Wed Dec 27, 2023 3:49 pm
by rbduck
I have something that has just recently started. When I open Thetis, the terminator between the Panadapter and Waterfall is located about 25% off the bottom of the GUI. I've tried what I thought was the obvious solution to the issue. I've also went back and listened to the past few of Richie's videos. What do I have to do to save to move the position upward to the middle of the GUI? I know how to move it. I just need to know how to save it.....
Re: Thetis opening with Panafall terminator too low
Posted: Wed Dec 27, 2023 4:11 pm
by ramdor
Check that that special panafall mode is unchecked, in the spot form. It will move like that and override the position if checked and Track is ON.
- special_pana.png (65.61 KiB) Viewed 2920 times
Re: Thetis opening with Panafall terminator too low
Posted: Wed Dec 27, 2023 4:28 pm
by rbduck
ramdor wrote:Check that that special panafall mode is unchecked, in the spot form. It will move like that and override the position if checked and Track is ON.
special_pana.png
That was absolutely the information I needed to correct my setup. The "Special Panafall mode" box was enabled. Thanks Richie for the fast reply and also thanks for the cmASIO video. That cleared a few things up for me as well.
Re: Thetis opening with Panafall terminator too low
Posted: Wed Dec 27, 2023 5:59 pm
by Trucker
Thanks for posting this. I had noticed the same thing.
James
WD5GWY